Our throttle assembly was sticking so I tore it apart and there are 2 bearings in there. Just wanted to post this info for anyone else that needs to do this. There is a 608 and a 6902 bearing in there and also a 15 x 26 x 4.5 seal. You might as well pick these up before you start the job. I also drilled and tapped ( short 1/4" bolt for plug) the top of the assembly so I could fill it with oil as well. While throttle cable was off I slipped a short piece of 3/8" ID hose over the end, put some oil in the hose then blew it into cable with air gun. Forced the oil right through cable to carb. Everything nice snd smooth now. Also sealed up assembly with gasket maker to hold the oil.
↧